Enforcer alarm engineer manual

 · Had an alarm fitted (pyronix enforcer 3 I think) in Sept. Engineer was a sub working for the alarm company. I asked him for code, he was squirming for ages, and I . Enforcer Programming Manual Page: 6 3. General Information Default Codes User: Master Manager: Engineers: Initial Power Up Power up the Enforcer WE system, an alarm will be generated. Proceed to the nearest keypad. Your engineer may have set up the system so that either an ‘Anti-Code’ or ‘Engineer Restore’ is required in order to fully reset the alarm system. What this means is that there will be certain conditions (specified by your engineer in the programming) that will require more than just your user code/tag to restore the system back to its.

have fitted the enforcer about 50 times in the past 6 months. (reg installer) customers love it yes it has a fee for the app but your alarm company should tell you the cost or do what we do and chuck it in on the annual service. the system is so easy to use but on the engine's side we can do almost anything for the customers with different sensors. User Manual Page: 4 1. Introduction button to be pressed (depending what the exit mode is programmed as by the engineer). Once the alarm panel is in this 'setting' stage, it is possible to 'quick set' the system by pressing the same button again; this will reduce the time to set to 'immediate setting'. CHAPTER 9: ANTI CODE / ENGINEER RESTORE Anti-Code Your engineer may have set up the system so that either an 'anti code' or engineer restore is required in order to fully restore the system (your code will still silence the alarm, just not restore the system). After alarm activation has occurred, enter your user code to silence the alarm.

This ENFORCER security system contains many innovative features and unique functions. Please read this Owners Manual carefully in order to understand all of this alarm’s security and convenience features. Some features may require the addition of sensors or accessories not included with this alarm. Please consult your professional SECO-LARM dealer. Enforcer 10 User Guide 11 Dial Out Menu Calls the UDL software. Allow Engineer Menu Enables or disables engineer access. Block UDL Set Blocks remote setting from the PC software. Block UDL Blocks uploading/downloading from the PC software. System Sounds Demo Demonstrates all the sounds of the alarm system. Exit Manager Mode Exits Master Manager mode. Enforcer Programming Manual Page: 6 3. General Information Default Codes User: Master Manager: Engineers: Initial Power Up Power up the Enforcer WE system, an alarm will be generated. Proceed to the nearest keypad.