Adjust a gate manual

 · Attach STRIKER BAR from the Gate Latch Kit (F) to the inside gate frame at the desired height use the 4 HEX HEAD SELF-TAPPING SCREWS (I). Align the LATCH with the Striker Bar and attach to post using INCH ROUNDHEAD WOOD SCREWS (K). By adjusting the TURNBUCKLE you can fine tune the gate latch to give a perfect fit. 1” 2x4’s Not Included. STEP 7: ADJUST-A-GATE™ ALL STEEL GATE FRAME SYSTEM We recommend using our GAP FILLER TUBES, Model #LTP, pack of three. TWO for the hinge-side gate post and ONE for the latch-side gate post. Using the self-tapping screws included, attach these to the gate posts, at the correct height for the hinges and latch. Follow instructions included with your. hole at the top of the gate frame, on the hinge side. Install the Truss Cable Kit (#3) by hooking the Turnbuckle into the hole located at the bottom of the gate frame on the latch side. Use the clamp provided to secure the cable, cut off excess. Adjust Turnbuckle to mild tension. Install Striker (#6) to gateframe. Striker Latch STEP www.doorway.ru Size: 2MB.

Test the gate operator monthly. The gate MUST reverse on contact with a rigid object or stop when an object activates the non-contact sensors. After adjusting the force or the limit of travel, retest the gate operator, Failure to adjust and retest the gate operator properly can increase the risk of injury or death. 5. User Manuals Simplified. Home» frisco» frisco Pet Gate 3 Panel Instruction Manual frisco Pet Gate 3 Panel Instruction Manual Contents [ hide 1 frisco™ better pet goods Pet Gate 3 Panel INSTRUCTION MANUAL CLEANING TIP WARNINGS AND CAUTIONS GET SET THE TOOLS FOR THE JOB FIRST GOES THE GATE INSTALLING THE GATE. of the pin is 1" from the post. That will set the proper clearance for the gate to swing. — Center Point STEP 3: ASSEMBLE POSITION GATE FRAME Latch Side Vertical Upright The WoodShades gate can be used for 5' 6' high fences and will adjust to virtually any opening from 36" to 72".

for manual gate operation (see page 1). 4. The gate and operator installation must comply with any ap-plicable local codes. 5. This gate operator is intended for vehicular gates only. A separate entrance or gate must be installed for pedestrian use (see page 6). 6. Always keep people and objects away from the gate and its area of travel. Step 1: Measure distance post to post to find gate opening. For this demonstration we have fabricated a 3 foot gate. Step 2: Lay out gate uprights which have horizontal rails attached. Notice the prefabrictaed tabs at the top and bottom Step 3: Insert Horizontal Slip Members into left and right. Ready Gate (Anti-Sag Kit)for Wood Gates. Step 1 Installing Post Hinges. Step One Installing Post Hinges. The Adjust-A-Gate™ is made to swing in. With this in mind you will want to locate your hinges toward the back edge Step Two Assemble Gate Frame. Step Two Assemble Gate Frame. The.